I was at the Tx/Rx Labs in Houston today to finish my quad today during the open house. I did more then finish working on it..... I maidened  it in front of  about 10 people I am glad it didn't tip over the side crashing.

Here is more details on the quad. 

Bill of materials

4 - NTM Prop Drive Series 35-30 1100kv / 380w

4- TURNIGY Plush 30amp Speed Controller ( Hobbyking doesnt stock the ESC I have used but this is a drop in replacement. )

Flight controller Hobby King KK2

OrangeRx R610 Spektrum DSM2 6Ch 2.4Ghz Receiver (w/ Sat Port)

The booms are from Home Depot. They are towel racks.

The nuts and bolts are also from Home Depot.

The frame is a custom design that I cut on the laser cutter ( if any one wants me to cut them one just leave a message in the comments)

During the maiden I was surprised at the KK2s stability right out of the box. It did have some oscillation but that can be easily tuned out. I am glad I didn't have to bother with pots like I had to when using the older KK boards to get it to the point where it would not tip over.

I just gave it throttle and it took off without any problems.

I am going to finish tuning the PI in the morning and after that I can fly it a bit more aggressively to see what this thing will do before i have to take it apart to take it to Turkey.

I'll post a video when i get a chance.

Gig'em, Aggies !